Overview 3
Display unit
1 Display unit
2 Hydraulic oil temperature indicator
3 Charging indicator
4 Engine oil pressure indicator / engine oil
level indicator (special equipment)
5 Electrical controller fault
6 Engine coolant temperature indicator
7 Joystick display electronically unlocked
8 Particle filter warning
9 Symbol without function
10 Water in the fuel filter (special equipment)
11 Hydraulic oil microfilter indicator (special
equipment)
12 Level display for diesel tank, LPG tank /
replacement cylinders or CNG tank
13 Symbol for "Particle filter"
14 Symbol without function
15 Symbol for "Service interval exceeded"
16 Operating hours symbol
17 Operating hours display
18 Symbol without function
19 Symbol for "Clock display (am/pm)"
20 Symbol without function
21 Function key
22 Reset button
23 Time display
24 "Do not start the engine" symbol
25 Symbol for "Parking brake applied"
26 Symbol for "Operating hours until the next
service" (shown for only 5 sec in the display
(17))
27 Symbol for "Seat belt not fastened" (special
equipment)
28 Text field
29 "Lift mast positioning" symbol active (special
equipment)
30 Display
31 Air filter vacuum indicator
32 Coolant level indicator
33 Preheating indicator (function only available
on diesel trucks)
34 Gas system error light (function only avail-
able on LPG trucks)
35 Engine malfunction warning light
The display unit (1) is mounted to the top right on the overhead guard. It is positioned within the
driver’s field of vision and provides centralised information about all functions of the truck. After
the key switch has been switched on, a self-test of the display unit is then performed. During the
self-test, all indicator lights and the displays are activated.
Display element
Function
Possible malfunctions
Remedy
Insufficient oil in the hydraulic
circuit
Incorrect oil used
Oil filter clogged
O
il cooler contaminated
(2) Hydraulic oil temperature
indicator
(red)
- Lights up if the maximum
permissible temperature is
reached. A buzzer also sounds
if the temperature limit is
exceeded.
When the "Engine protection"*
function is activated):
- Truck moves at creep speed
(approx. 2 km/h)
Display in the text field (28):
- Error code
X205
Switch off the buzzer with the
reset button (22)
Operating Instructions – 394 807 10 01 EN – 07/2011 23
To Next Page
Loading...
