4 Operation
Standard equipment
"speed reduction" special function, the seat
belt must be worn even at the reduced speed.
The automatic blocking mechanism prevents
the belt from being extended whenever the
industrial truck is on a steep slope. It is then not
possible to pull the belt any further out of the
retractor. To release the automatic blocking
mechanism, carefully move the industrial truck
so that it is no longer positioned on a slope.
Whileusingthetruck(e.g. d
riving, operating
lift mast etc.), adopt a sitt
ing position as far
back as possible so that the d
river’s back
rests against the seat backr
est. The belt
retractor automatic blocki
ng mechanism
offers sufficient freedom o
f movement on the
seat for normal use of the tr
uck.
Fastening the seat belt
¾ Pull the seat belt (2) smoothly out of the
retractor to the left.
¾ Position belt over the lap, not over the
stomach.
¾ Snap the buckle guide (1
)intoplaceinthe
buckle (4).
¾ Check seat belt tension.
The belt must fit close to the body.
Unfastening the seat belt
¾ Push the red button (5
) on the buckle (4).
¾ Manually feed the buckle guide (1) back into
the retractor (3).
NOTE
The automatic blocking mechanism may be
triggered if the web belt runs in too quickly and
the buckle guide strikes the housing. The web
belt cannot be pulled out with the usual force.
42 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
