Operation 4
Standard equipment
temperature and altitude, this may take
more than 1 minute.
If the engine stalls, the "Do not start the
engine" symbol will appear (11).
NOTE
A block against repeat starting is active and
the engine cannot be started.
¾ Always leave the ignition switched on until
the symbol goes out.
¾ Then try to restart.
Leave a break of at least 1 minute between
each engine start to protect the battery. If the
engine still does not start at the third attempt,
see: Malfunctions, Causes and Remedies.
The charging and engine oil pressure indi-
cators must go out as soon as the engine is
running smoothly.
The engine speed is cont
rolled automatically,
depending on the load o
n the engine.
NOTE
Do not allow the engine to warm up at idle
speed. When under load, drive the truck at a
brisk speed. The engine will quickly reach its
operating temperature.
Switching off the engine
CAUTION
For engines with a turbocharger, the high speed
of the turbocharger shaft (approx. 100,000 rpmat
full load) could cause the shaft bearing to run dry
through lack of lubrication, thus damaging it.
Do not switch off the engine when under full load,
instead allow it to run on for a few minutes at low
speed.
Operating Instructions – 394 807 10 01 EN – 07/2011 45
To Next Page
Loading...
