4 Operation
Standard equipment
Approaching gradients
¾ Press the stop pedal (3) all the way down.
¾ Release the parking brake leve
r(1)and
move it downwards as far as the s
top.
¾ Take your foot half way off the stop pedal.
¾ Actuate accelerator pedal (2) or (4).
¾ Slowly take your foot compl
etely off the stop
pedal.
The brake has been released and the truck will
now move without rolling backwards.
Stopping
¾ Slowly release the accelerator pedal after
pressing it.
The hydrostatic drive wi
ll act as a service
brake.
¾ When stopping on inclines, leave both
feet on the pedals and press the pedal in
the "uphill" drive direction down slightly to
counterbalance the slip of the drive. This
slip is caused by technical factors.
¾ If stopping for an exten
ded period of time,
press the stop pedal (3)
.
¾ If you ever have to leave the truck with the
engine still running, e.g. to do minor jobs
in the direct vicinity of the truck (opening
doors, disconnecting trailers etc.), it is
essential to activate the parking brake (turn
the parking brake lever (1) in a clockwise
direction until it engages), and unlatch the
seat belt. If you are leaving the truck for a
longer period of time, switch off the engine
and activate the parking brake.
¾ When leaving the truck, remove the ignition
key.
48 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
