4 Operation
Standard equipment
¾ Place your foot on accelerator pedal (3).
¾ Turn the parking brake lever (1) in a clock-
wise direction until it engages.
The parking brake is actuated (
it is only
possibletostarttheenginewi
th the parking
brake actuated).
¾ Insert the switch key (2) into the ignition
and starting switch and turn from the zero
position to position "I".
The electrical system is switched on.
¾ Look at the display unit (4).
NOTE
After the ignitio
n has been switched on, the
display unit will
perform a self-test. The
displays all lig
ht up for approx. 2 seconds and
the operating ho
urs until the next service are
displayed for 5 s
econds in the display unit (4)
display field (10
). During this time the symbol
(13) remains lit
. After 5 seconds the display
reverts automat
ically to the operating hours. If
the buzzer sound
s (particle filter system fault),
check the lights
(see Malfunctions, Causes
and Remedies — d
iesel engine). If the buzzer
continues to so
und, please contact your local
authorised dea
ler. If the symbol (9) flashes
or lights up, th
e set service interval has been
exceeded. The m
aintenance work that is
due must be perf
ormed. Please contact your
authorised dea
ler.
The following indicators light up:
• Parking brake applied symbol (12)
• Engine oil pre
ssure indicator (6)
• Charging indicator (5)
• Glow plug indicator (14)
•Particlefilte
r symbol (7) (only if particle filter
is present).
50 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
