Loadrite PRO - The Ready Screen; Weighing a Load

LOADRITE PRO OPERATING MANUAL
6
If it is time to check zero, the Loadrite will
display the Check Zero message to
remind you.
More information about Ready screen and
Check Zero screen will be covered later
in this manual.
Check
Zero
The Ready Screen
The Ready screen shows the product name and the short total for that
product. The short total is simply the sum of loads since you last cleared
the total.
When the Ready screen is displayed, the Loadrite is in Total mode and is
ready to weigh. Note that Sand in the below example represents the
current product of choice. Your Loadrite may be configured differently, and
hence, a different product name may appear on the screen.
Ready
Sand
3400
The Loadrite is ready to weigh
Current product to be loaded
Current total loaded
Weighing a Load
(Weights shown are examples only)
Loadrite is ready to
weigh sand.
(Current total 3400)
Ready
Sand
3400
Raise the load
smoothly past the
trigger point using
normal engine revs.
The bucket must be
fully rolled back
during weighing.
Weighing
3400