LOADRITE PRO OPERATING MANUAL
30
Auto tare value look up
This function is similar to Auto target value look up, except that it handles
tare values obviously. You can recall the tare value from memory by either
entering a number or scrolling through a list of truck names. The
procedures are the same as the Auto target value look up.
Auto-increment
Auto-increment function is an optional that is selected during installation. If
auto-increment is enabled, data value will be made to increment
automatically when Short Total is cleared. The data value can only be
viewed but cannot be edited.
Odometer (Distance/Mileage Recorder)
Odometer function is an option that is selected during installation. With
properly installed and configured hardware, the data field can be used to
display the odometer/distance/mileage value. If enabled, the data field will
be updated regularly with the current odometer/distance/mileage value. The
data value can only be viewed but cannot be edited.
Automatic Data Prompt
Automatic Data Prompt is an optional function that is selected during
installation. If enabled, the Loadrite automatically prompt for data field
entries when a new product is selected.
Data Suspend
Data Suspend is a feature that allows operator to temporarily suspend all
data values (except odometer/distance/mileage value) and set them to 0
(zero). Data Suspend is an optional function that is selected during
installation.
To suspend data
When the Loadrite is in Ready mode, press
. The Loadrite displays the current
setting.
Customer
Joe
To Next Page
Loading...