Loadrite PRO - Static Weigh function; Adding a Load

LOADRITE PRO OPERATING MANUAL
7
A short time later,
the Loadrite beeps,
turns the TRIG
indicator light on
and displays the
load lifted (2200).
Sand
3400
2200
The trigger point is where the metal plate passes the body of the trigger.
Static Weigh function
The Loadrite has an option known as ‘Static Weigh’. When this is used, the
weight display is always ‘live’ and no trigger is used.
The ‘Trigger’ light is used to indicate that the weight being measured is
‘stable’ (not changing too much) and therefore can be Added, Subtracted or
Zeroed.
Your Loadrite dealer will have configured the Static Weigh function if
required. Other functions described in this manual operate in a similar
manner, regardless of whether Static Weigh is being used.
Adding a Load
(Weights shown are examples only)
Before lifting:
(Current total 5600)
Ready
Sand
5600
Raise the load smoothly past the trigger
point using normal engine revs.
The Loadrite beeps and displays the load.
(Weight of load 2200)
Sand
5600
2200
Press .
The Loadrite updates the total and returns
to the Ready state.
(New total 7800)
Ready
Sand
7800