Loadrite PRO - Recalling Last Load

LOADRITE PRO OPERATING MANUAL
18
Recalling Last Load
The Recall function is equivalent to lifting the same load again and can be
used to correct mistakes.
You can recall and display the last load if it has been:
• Added
• Subtracted, or
• Timed out (ignored).
To Recall the previously lifted weight
(Weights shown are examples only)
Current total 5600.
Press
G H I
.
Ready
Sand
5600
The Loadrite beeps and displays the last
load.
(Weight of last load 2200)
Sand
5600
2200
If the last action was an “add”, you can
subtract.
If the last action was a “subtract”, you can
add.
(Example: subtracting a load that was
previously added, new total 3400)
Ready
Sand
3400
If you press a key that is not allowed in the circumstances, such as
when the recalled load was previously added, the Loadrite ignores the key
press.