Loadrite PRO - Page 23

LOADRITE PRO OPERATING MANUAL
17
At this point a ZERO check lift should be carried out as described in the
previous section.
The reminder can be cleared without doing a ZERO check, by simply
continuing with normal operation. However, a ZERO error can affect the
accuracy of lifted weights so it is important to do a ZERO check regularly.
The automatic CHECK ZERO reminder will not occur if the operator is
checking the ZERO often enough.
The automatic CHECK ZERO prompt is an optional function that is selected
during installation.
Zeroing when Auto Add is On
The procedure to zero may be different when Auto Add is on and Auto Add
Time is set to 0. If this is how your Loadrite is configured, you will need to
carry out the following procedure:
Before lifting:
Press the key.
Zero
Lift
Raise the empty bucket smoothly past the
trigger point. The Loadrite beeps and
performs the zero adjustment.
Zero
Updated
If Auto Add is not on, or Auto Add Time is not set to 0, follow the standard
procedure to zero (page 15).
Auto-Add is described on page 14.