Loadrite PRO - Page 22

LOADRITE PRO OPERATING MANUAL
16
Raise the bucket smoothly past the trigger
point using normal engine revs.
The Loadrite beeps and displays the load.
(Example weight 20)
Sand
0
20
Press the key.
The Loadrite performs the zero adjustment
and returns to the Ready state.
Ready
Sand
0
Large ZERO Error
If the weight is greater than 5% of full scale, when you press , the
Loadrite prompts Bucket Empty? If it is, press ENT which will zero the
empty bucket. Pressing EXIT will not zero the scale
If the weight is greater than 10% of full scale, when you press , the
Loadrite displays Too heavy, zero aborted and does not alter any
settings.
This prevents any accidental zeroing of valid weights.
If the bucket is empty and this message still occurs, there may be a fault in
the system. The Loadrite should be checked and, if necessary, re-
calibrated.
Check Zero Prompt
Check
Zero
This function automatically reminds the operator to check ZERO
occasionally. Changes in the ZERO occur more often while the machine is
warming up.
When first turned on, after having been off for more than one hour, the
Loadrite will remind the operator to do a ZERO check:
• Every 15 minutes for the first hour
• Every 30 minutes thereafter