Loadrite PRO - Measuring a Tare weight

LOADRITE PRO OPERATING MANUAL
21
Tare Function
The Loadrite has two ways of using Tare and this is selected at time of
installation. The Tare can work either with the lifted weight, or the total
weight. This is explained in more detail below.
Your Loadrite dealer will set up how Tare is to operate with your machine.
Tare on Lifted weight
In this mode, the Tare function can be used, for example, to allow for the
weight of a pallet. When weighing, the Loadrite automatically deducts the
tare from the lifted weight and displays the net weight of the load.
Tare on Total weight
In this mode the entered Tare value is applied to the displayed Total value.
The Loadrite automatically adds the total for the currently product to the
Tare value and displays this value.
This mode if useful when loading vehicles which display their Tare weight
and maximum weight. The operator enters the Tare value into the Loadrite,
then loads the vehicle until the displayed total is equal to the vehicles
maximum loaded weight.
Entering a Tare weight using the keypad
You can enter a tare using the keypad or by measuring the weight. To enter
a Tare with the keypad, do the following steps. (When Tare is set to work on
the Total, the Tare value is normally entered with the keypad).
Press
J K L
.
Tare?
0
Key in the tare weight and press to
accept.
Tare?
50