LOADRITE PRO OPERATING MANUAL
10
3 Weighing Overview
Weighing Modes
While individual bucket weight can be measured, the Loadrite also has an
ability to accumulate how much weight you have loaded on to a truck. The
main weighing modes are shown in the following table. The modes that are
available in a particular Loadrite depend on the installation.
Mode Description
Total As you add bucket loads, the weights are added to the totals.
The short total is displayed.
Target A target weight is entered into the Loadrite. As you add bucket
loads, the remaining value to reach the target is displayed.
Batch Allows you to weigh and load different products according to a
predefined recipe that specifies the required proportions. You
enter the grand batch target. Loadrite will work out individual
product weights needed.
Mix Similar to Batch mode except that the grand target is not
required. You load the first product to a certain amount.
Loadrite will work out how much you need for the other
products in the mix, based on the predefined recipe.
Blend Allows you to load fixed numbers of bucketful's of different
products according to a predefined recipe.
The normal mode of operation is Total mode, which uses the Ready
screen. To return to Total mode from any of the other modes, press
.
For Batch/Mix/Blend mode, you will return to Total mode when you clear the
grand total, or when you select a product that is not in the recipe.
Changing to Target, Batch, Mix or Blend mode
If more than one of the above modes are enabled, you must first select the
mode you want to enter.
To Next Page
Loading...
