Loadrite PRO - Large ZERO Error; Check Zero Prompt

90 pages

Save Page as PDF

To Next Page

To Previous Page

LOADRITE PRO OPERATING MANUAL

Press .

The Loadrite performs the zero adjustment

and returns to the Ready state.

Ready

Sand

More detailed information about Zeroing can be found on page 15.

Main Page

Default Chapter5
- Table of Contents5
1 Introduction7
- Indicator Lights8
- Keypad8
2 Quick Start Guide11
- Switching on11
- Standby11
- The Warm up Screen11
- The Ready Screen12
- Weighing a Load12
- Static Weigh Function13
- Adding a Load13
- Clearing the Short Total14
- Zeroing14
3 Weighing Overview16
- Weighing Modes16
- Short and Long Totals17
- Accurate Weighing17
- General Method of Weighing18
4 Weighing Procedures19
- Adding a Load19
- Auto Add20
- Subtracting a Load20
- Zeroing21
- Recalling Last Load24
- Viewing Long Total25
- Clearing Totals25
- Tare Function27
5 Product Management29
6 Data31
- Data Edit31
- Automatic Data Prompt36
- Data Suspend36
7 Target Mode38
8 Batch Mode41
- The Batch Screen42
- Viewing the Current Recipe43
- Changing the Recipe44
- Entering the Batch Total45
- Batch Weighing46
- Clearing the Batch Totals47
- Returning to Total Mode47
9 MIX Mode48
- The MIX Screen49
- MIX Weighing49
- Clearing the MIX Totals51
- Returning to Total Mode51
10 Blend Mode52
- The Blend Screen52
- Blend Weighing53
11 Split Mode55
12 Tip off58
13 Menu Options62
- Setup63
- Clock Setting (Clock)63
- Changing Scale Number (Scale#)63
- Clear All Long Totals (Clearall)64
- Auto Add On/Off Setting (Auto Add)64
- Rotary Trigger Position Screen (Trigscrn)64
- LD941 Data Module Properties (Module)65
- Data Edit (Dataedit)65
- Data List (Datalist)66
- Alarm Clock On/Off67
- Alarm Time Set67
- Self Test (Selftest)68
- Uplink (Uplink)68
14 Print Functions69
- Printed Data70
- Print Menu70
15 Obtaining the Best Accuracy76
- Lifting Speed76
- Trigger Point76
- Bounce76
- Centre of Gravity76
16 Error Messages77
- Bouncing Load77
- Check Power77
- Check Transducer77
- Check Trigger77
- Check Zero77
- Lift under Range78
- Module Data Lost78
- Module Error78
- Module Full78
- No Lock78
- Over Target78
- Overload79
- Poor Lift79
- Printer Disabled79
- Printer Error79
- Return under Range79
- Speed Changed80
- Too Heavy, Zero Aborted80
- Warm up Lift80
17 Specifications81
18 Output / Input Connections83
Appendix I Time and Date84
Appendix II Span Calibration Adjustment87

Loadrite PRO - Large ZERO Error; Check Zero Prompt

Table of Contents

Related product manuals