Loadrite PRO - Data List (DataList)

LOADRITE PRO OPERATING MANUAL
59
5. Press to accept the setting.
This function is only available if the Loadrite is configured to use rotary
trigger.
LD941 Data Module Properties (Module)
This function is available only if the LD940 MMS data logger feature has
been enabled during installation. Data Module Properties function enables
you to examine the properties and the status of the data logger module
connected to the Loadrite.
When activated, this function will do the following:
• Display software and hardware information of the data logger
• Perform self-test
• Display data usage
To access the Data Module Properties function:
1. Press
M N O
.
2. Use
5 6
to scroll to Module.
3. Press to select.
Data Edit (DataEdit)
Data Edit is an optional feature that is selected during installation.
This is the same Data Edit function as described in chapter 6 (page 25),
except that when accessed through the Menu it allows you to over-ride any
data setting, including auto-increment-type data.
To access the Data Edit function:
1. Press
M N O
.
2. Use
5 6
to scroll to DataEdit.
3. Press to select.