Loadrite PRO - Module Error; Module Full; No Lock; Over Target

LOADRITE PRO OPERATING MANUAL
73
OverTarg
1200
7400
Over Target message
Amount over the target value
Lifted weight
Auto-Add function will not automatically add over-target weight.
Overload
Overload means that the lifted weight exceeds the full scale (capacity)
setting. If the Overload Error is set during installation, overloaded weight
cannot be added.
Overload
1.200
Overload Message
Amount overloaded
Poor Lift
If a weighing error is close to but not greater than the tolerance limit, the
Loadrite displays the warning message Poor Lift.
The weight can be added as usual.
Printer Disabled
Print function has been disabled at installation.
Printer Error
The Loadrite has detected a fault in the printer.
Check that the printer is on-line and not out of paper.
Return Under Range
The Loadrite has detected that the Return pressure was too low.
This indicates a fault in either the pressure transducer or the cable that
connects the transducer.