LOADRITE PRO OPERATING MANUAL
15
To subtract a Load
(Weights shown are examples only)
Before the load Is lifted:
(Current total 5600)
Ready
Sand
5600
Raise the load smoothly past the trigger
point.
The Loadrite beeps and displays the load.
(Weight of load 2200)
Sand
5600
2200
Press
P Q R S
.
The Loadrite updates the total and returns
to the Ready state.
(New total 3400)
Ready
Sand
3400
In Target mode, the display is different. For details, see Target Mode on
page 32.
Zeroing
When you raise an empty bucket past the trigger point, the display should
read zero. However, due to build up of material in the bucket, a small zero
error may occur.
Zero error affects the accuracy of lifted weights.
To zero the Loadrite
Before lifting:
Make sure that the bucket is empty and
fully rolled back.
The loader must be on level ground.
Ready
Sand
0
To Next Page
Loading...
