Loadrite PRO - To reset to Target

LOADRITE PRO OPERATING MANUAL
33
As your “To Load” value approaches to zero, you are getting close to
finishing loading a truck. It does not have to be exactly zero, as long as it is
close. For example, if you have To Load value 20, it means that you are 20
under the target. If you have To Load value -20 (negative), it means that
you are 20 over the target.
To reset to Target
When you are finished loading a truck, you need to clear the total or reset
the target.
(Weights shown are examples only)
Press .
To Load
Sand
20
The Loadrite displays Target Reset for
a few seconds and then …
Target
Reset
9000
… resets the display to the current target.
To Load
Sand
9000