LOADRITE PRO OPERATING MANUAL
65
Print Docket
Print Last Docket function prints the data stored (e.g., ADD, SUBTRACT,
etc) between the two last CLEAR events. If the data is not stored, it will not
be printed. For example, if the Loadrite is not configured to log ADD
events, weights added will not be printed. This function requires internal
storage to be enabled. All configuration of this function is set during
installation.
This function will not work if CLEAR is not used as intended. For example,
you are loading sand. Halfway through, second truck comes in. You switch
product to rocks and start loading to the second truck (without clearing total
of sand). When you run this function, you will get the adds of sand plus the
adds and total of rocks.
Print Totals
This function prints the total amount of each product loaded today (since
midnight).
Sample Printout:
SAND 10320
PUMICE 10180
Print Loadout
This function prints out ALL print data stored in the Loadrite memory since
midnight.
This function gives a printout that is basically the same as if a printer
had been connected all the time. Depending on configuration, every
Add, Clear, Zero etc could be included in the printout.
Refer Sample Printout on following page.
To Next Page
Loading...
