Logicube Falcon-NEO User Manual

TYPES OF OPERATIONS
Logicube Falcon
®
-Neo User’s Manual 90
(CLI). See Section 9.2 for more information on how to
connect to the Falcon-NEO using the CLI.
This method will only work if the
INITIAL.DB profile does not have
a Config Lock Key saved. If the
INITIAL.DB has a Config Lock
Key configured, and the
password was forgotten, contact
Tech Support assistance.
Once connected to the Command Line Interface (CLI):
1. Login with the username “it” (without the
quotes) and the password “it” (without the
quotes).
2. From the main prompt, type command, then
press the enter key.
3. Type config then press the enter key.
4. Type db list then press the enter key. This will
show a list of profiles (or databases) saved. The
Falcon-NEO has one default profile called
initial.db. Any profiles added by users will
appear in this list. The db that shows an asterisk
(*) before the name is the current database or
configuration being loaded each time the
Falcon-NEO is turned on.
5. Type db load initial.db then press the Enter key
to load the default database. There should be a
response showing “Command (DbManagement)
Successful”.
6. Type db list again and there should be an
asterisk (*) on initial.db.
7. Turn the Falcon-NEO off using the power
button, then close the Telnet/SSH application.
8. Turn the Falcon-NEO on. When the Falcon-NEO
boots up, it will load the default configuration
(INITIAL.DB).
5.10.2.2 User Account Passwords
The Falcon-NEO comes with two built-in user accounts:
 logicube
 it

Logicube Falcon-NEO Specifications

General

Brand	Logicube
Model	Falcon-NEO
Category	Laboratory Equipment
Language	English