Logicube Falcon-NEO

QUICK START
Logicube Falcon
®
-Neo User’s Manual 36
3.11 Network Settings
The following tabs are seen in the Network settings screen:
Details on the different Network
Settings screens can be found in
Section 5.11: Network Settings.
 Interfaces – Interfaces – Allows the configuration of the network interface which include setting a
static IP address and allows certain network services to be enabled or disabled.
 HTTP Proxy – For the Falcon-NEO to be able to update software from a network (over the
internet), proxy settings may need to be set. Networks that have a proxy server for internet access
will require proxy settings for devices like the Falcon-NEO to connect to the Internet. This typically
includes a server (or IP address), a host port, a username and password.
3.12 Software Updates
New and improved software will be released from time to time. There are two ways to
update the software on the Falcon-NEO: From the web via a network connection or
from a USB drive.
Details on how to perform a software update, software
re-load, or firmware update can be found in Chapter
8: Updating/Loading/Re-loading Software.
3.13 Power Off
There are two tabs in the Power Off screen:
Details on the different Network
Settings screens can be found in
Section 5.13: Power Off.
POWER OFF – The Falcon-NEO can be remotely turned off or restarted by going to this tab. Additionally
the Falcon-NEO screen can be refreshed.
DRIVE POWER – Inactive drives connected to the Falcon-NEO can be set to go to standby mode in this
tab. The default is set to 0 minutes (OFF).