PRINTING
Logicube Falcon
®
-Neo User’s Manual 142
14.2.1 Connecting/Disconnecting the FireWire Module
The Falcon-NEO FireWire Module is not hot-swappable.
Always turn the Falcon-NEO off before connecting or
disconnecting the FireWire Module to/from the Falcon-
NEO. Drives, enclosures, or Mac systems connected
1. Turn the Falcon-NEO OFF.
2. Connect or disconnect the FireWire Module to one of the PCIe ports on the
Falcon-NEO (PCIE_S or PCIE_D). Repeat this step if a second FireWire module
needs to be connected or disconnected.
3. Once the FireWire module is connected to the Falcon-NEO, the Falcon-NEO can
now be used with FireWire drives, enclosures, or Mac® systems (with FireWire or
Thunderbolt 1 or Thunderbolt 2 with a Thunderbolt to FireWire adapter) booted
in Target Disk Mode. Any connected FireWire drive, enclosure, or Mac system
should appear like any other drive:
To Next Page
Loading...