Logicube Falcon-NEO User Manual

TYPES OF OPERATIONS
Logicube Falcon
®
-Neo User’s Manual 68
The Falcon-NEO will check the Destination drive
for formatting prior to being used as a Destination
or Repository for Imaging using Drive to File, File
to File, Partition to File, or Net Traffic to File. If
the drive has not been formatted by the Falcon-
NEO, the Destination drive must be formatted
using the Falcon-NEO prior to being used as a
Destination for Imaging using either mode above.
Tap this icon to set the Falcon-NEO to format the drive (with or without
encryption). The following settings are available:
 Format – When set to ON, the Falcon-NEO will format the
Destination drive with or without encryption. The drive will be
formatted with the user’s choice of file system (EXT4, NTFS,
exFAT, or FAT32). When set to OFF, the Falcon-NEO will not
format or encrypt the selected drive.
o File System – Select the file system to be used to format
the Destination drive. Users can select from EXT4, NTFS,
exFAT, or FAT32.
o Encryption – Select ON to format the drive with
encryption.
For more information on encrypted
Destination drives, please see Chapter
7: Drive Encryption and Decryption.
5.3.3 Case Info
The Case Info setting allows users to enter some information about the case. Case Info
and is not required to start a Hash or Verify operation.
Information entered here will appear in the logs. More information on the Case Info
screen can be found in Section 4.3.1.

Logicube Falcon-NEO Specifications

General

Brand	Logicube
Model	Falcon-NEO
Category	Laboratory Equipment
Language	English