Logicube Falcon-NEO - Viewing Source Drives Over the Network Using iSCSI

Logicube Falcon
®
-NEO User’s Manual 116
8: Updating/Loading/Re-loading Software
8.0 Important Notes on Updating/Loading/Re-loading Software
Before starting the software update process:
 If updating From Network:
- Wait at least 5 minutes after turning the Falcon-NEO on or connecting the network cable
before starting the software update.
- Make sure all drives and drive adapters are disconnected.
- Do not disconnect the network cable during the update process.
 If updating From USB Drive:
- Disconnect the network cable (if connected).
- Wait at least 5 minutes after turning the Falcon-NEO on or disconnecting the network
cable before starting the software update.
- Except for the USB flash drive that contains the software update, make sure all drives and
drive adapters are disconnected.
- Keep the network cable disconnected until after the software update finishes.
8.1 Updating/Loading/Re-loading Software – Introduction
New and improved software will be released from time to time and will always be available on the Falcon-
NEO support page. Browse to http://www.logicube.com. Point your mouse to Tech Support and select
Product Knowledge Base or go directly to http://www.logicube.com/knowledge/forensic-falcon-neo.
8.2 Updating/Loading/Re-loading Software Instructions
There are two methods of how to update the Falcon-NEO Ultimate software:
A. FROM NETWORK – Over the Internet through a network connection
B. FROM USB DRIVE – Through a software file download onto a USB drive flash.
The actual software installation will take about 5 minutes. If FROM
NETWORK was chosen, the total time can exceed 10 to 20 minutes
(or longer) depending on Internet speeds and Internet traffic.
The most up-to-date instructions on
updating the software can be found
on the Falcon-NEO’s support page.