Logicube Falcon-NEO User Manual

IMAGING
Logicube Falcon
®
-Neo User’s Manual 54
When finished, the status will show “COMPLETED”. It is recommended to tap Reset Task to reset the task,
so the drive bays properly reset and not show as being used or assigned for other tasks.
The number of bytes shown on the progress bar is not the actual
size of the drive. This is the actual data being processed. When
‘Verify’ is set to “Yes”, the reported number will double in size.
The Falcon-NEO can automatically span to two (or more) Destination drives when
using Drive to File mode (DD, E01, EX01, or DMG). When the Destination drive is
full and the remaining data to be imaged will not fit, Falcon-NEO will prompt for
another drive. Information on Drive Spanning can be found in Section 3.1.7.

Logicube Falcon-NEO Specifications

General

Brand	Logicube
Model	Falcon-NEO
Category	Laboratory Equipment
Language	English