- 39 -
Messages
10.15
17 Messages
17.1 Information and error messages HandyTIG 180 DC ControlPro
Code Symptom Cause Remedy
H06 EEProm write/read error Communication with EEProm faulty Switch machine off and on again, exe-
cute master reset
E01 Thermal overload Duty cycle exceeded Allow switched-on machine to cool down
for a few minutes.
Fan defective Switch unit off and on, fan must start up
for a short period, inform service.
E02 Power section Power section start-up faulty Inform Service
E03 Current sensor Current sensor defective Inform Service
E06 Overvoltage Mains voltage too high Check mains voltage
E07 Supply voltage 15V Fault internal supply voltage Inform Service
E10 Torch/remote control Remote control, torch or connections
defective
Check or replace torch and remote con-
trol
E14 Control panel Component group control panel faulty Inform Service
17.2 Error messages HandyTIG 180 DC BasicPlus
Symptom Cause Remedy
LED mains 37 and LED malfunc-
tion 35 are not lit
mains fuse defect exchange mains fuse
neutral, mains phase missing check mains cable / mains extension cable
LED mains 37 is lit and LED mal-
function 35 ashes
machine error Turn off machine, wait until LED mains 12 is off,
turn machine on again If malfunction still persits,
contact Service
LED mains 37 is lit, but no welding
current
ground cable not connected or de-
fect
check ground cable, exchange if necessary
electrode holder or torch not con-
nected or defect
check electrode holder or torch, exchange if
necessary
LED malfunction 35 is lit con-
stantly
machine is overheated, ED ex-
ceeded
let machine cool down in standby
To Next Page
Loading...
Need help?
General
