LSIS sv-ig5a User Manual

5-4
 Function group 1
LED
display
Address
for
communi
cation
Paramete
r name
Min/Max
range
Description
Factory
defaults
Adj.
during
run
Page
F21
1)
A215
[Max
frequency
]
40 ~ 400
[Hz]
This parameter sets the highest frequency
the inverter can output.
It is frequency reference for Accel/Decel
(See H70)
60.00
X
7-21
Caution
Any frequency cannot be set above Max
frequency except Base frequency
F22
A216
[Base
frequency
]
30 ~ 400
[Hz]
The inverter outputs its rated voltage to the
motor at this frequency (see motor
nameplate).
60.00
X
7-17
F23
A217
[Start
frequency
]
0.1 ~ 10
[Hz]
The inverter starts to output its voltage at
this frequency.
It is the frequency low limit.
0.50
X
7-21
F24
A218
[Frequen
cy
high/low
limit
select]
0 ~ 1
This parameter sets high and low limit of
run frequency.
0
X
7-21
F25
2)
A219
[Frequen
cy high
limit]
0 ~ 400
[Hz]
This parameter sets high limit of the run
frequency.
It cannot be set above F21 – [Max
frequency].
60.00
X
F26
A21A
[Frequen
cy low
limit]
0 ~ 400
[Hz]
This parameter sets low limit of the run
frequency.
It cannot be set above F25 - [Frequency
high limit] and below F23 – [Start
frequency].
0.50
X
F27
A21B
[Torque
Boost
select]
0 ~ 1
0
Manual torque boost
0
X
7-19
1
Auto torque boost
F28
A21C
[Torque
boost in
forward
direction]
0 ~ 15
[%]
This parameter sets the amount of torque
boost applied to a motor during forward
run.
It is set in percent of Max output voltage.
2
X
7-19
F29
A21D
[Torque
boost in
reverse
direction]
This parameter sets the amount of torque
boost applied to a motor during reverse
run.
It is set as a percent of Max output voltage
2
X
7-19
1)
: If H40 is set to 3 (Sensorless vector), Max. frequency is settable up to 300Hz.
2)
: Only displayed when F24 (Frequency high/low limit select) is set to 1.
For Service Call 800-848-2504
For Service Call 800-848-2504

LSIS sv-ig5a Specifications

General

Brand	LSIS
Model	sv-ig5a
Category	Inverter
Language	English