LSIS XBF-AD04A - Page 560

Chapter 15 PID Function (Built-in function)
15 - 11
15.2.3 PID control parameter setting
To use the built-in PID control function of XGB series, it is necessary to set PID control parameters by
loops in the parameter window and operate it though the commands. Here, it explains parameters to
use PID control functions and how to set them.
(1) PID parameter settings
Follow the steps below to set the PID control function parameters of XGB series.
(a) If selecting the built-in parameters in Parameter of the project window, it shows the built-in
parameter setting window as in below figure.
< Figure 15.7 Parameters setting window >
(b) If selecting PID Control, it shows the PID control parameter setting window as in below figure.
[ Figure 15.8 Built-in PID function parameters setting window ]