215585 112 Revision A
NOTE:
Ensure there is no contact with the rear link arm when the hitch swing cylinder extends.
2. With the cylinder disconnected from the rear arm link, using the tractor’s hydraulics, extend and retract swing
cylinder (A) several times to purge any air in the cylinder.
$
Figure 6.6: Hydraulic System
$
%
&
'
(
Figure 6.7: Rear Arm Link
3. Align the clevis pinholes in cylinder clevis (B), cam arm (C),
and rear link arm (A).
4. Install clevis pin (D) and secure with cotter pin (E) (not
shown).
COMPLETING ROTARY DISC PULL-TYPE ASSEMBLY
To Next Page
Loading...
