Maeda MC815C - Oil and Water Quantities List; Rated Total Load Chart

1-8
5. OIL AND WATER QUANTITIES LIST
Use of lubricating oil should vary with changes in temperature.
• A specified oil quantity is defined as a total quantity of oil including that for unit piping, and a replacement oil
quantity is defined as a quantity of oil to be replaced at inspection and maintenance.
• Always use SAE10W-CD, SAE10W-30CD, or SAE10W-40CD to start the engine with temperature at 0 °C or
below despite rise in diurnal temperature.
• Be sure to use our recommended abrasion-resistant hydraulic oil for the hydraulic oil system.
ISO VG32 is used when the product was shipped.
• For adjustment of antifreeze concentrations in coolant with temperature at -10 °C or below, see “Inspection and
Maintenance 9.10 Every 1000 Hours Maintenance [1] Cleaning Engine Cooling System”.
6. RATED TOTAL LOAD CHART
・N-mode (normal-mode)
The rated total load table for the extended outrigger applies.
・P-mode (power-mode)
The rated total load table for P-mode applies only within the ranges of 335
to 0°, and 0 to 25°.
Outside the above ranges, the rated total load is the same as for N-mode.