Maeda MC815C - Page 6

0-4
Item
Page
8. ELECTRICAL UNITS 2-97
8.1 CABIN INTERIOR 2-97
8.1.1 NAME OF EACH CONTROL PART 2-97
8.1.2 OUTRIGGER OPERATION PANEL 2-98
8.1.3 LEFT CONTROL LEVER 2-98
8.1.4 RIGHT CONTROL LEVER 2-101
8.1.5 MONITOR 2-104
8.1.6 LIST OF ERROR CODES
2-106
8.1.7 CONSUMABLES DISPLAY
2-111
8.1.8 FUSE BOX
2-112
8.2 CONTROLLER
2-113
8.2.1 CONTROLLER LAYOUT
2-113
8.2.2 LOWER PART CONTROLLER PIN NUMBERS 2-115
8.2.3 IO UNIT PIN NUMBERS 2-118
8.3 HARNESS ASSEMBLY 2-119
8.3.1 HARNESS OVERVIEW FIGURE 2-119
8.3.2 HARNESS PRODUCT NAME / NUMBER 2-119
8.3.3 OUTRIGGER SENSOR HARNESS 2-120
8.3.4 ENGINE HARNESS 2-121
8.3.5 CONSOLE HARNESS
2-122
8.3.6 VALVE HARNESS 2-123
8.3.7 DISPLAY HARNESS 2-124
8.3.8 BOOM HARNESS 2-125
8.4 ELECTRICAL FITTINGS OUTSIDE THE CABIN
2-126
8.4.1 LED LIGHT 2-126
8.4.2 SURVEILLANCE CAMERAS 2-127
8.5 SENSORS
2-128
8.5.1 PRESSURE AND OIL TEMPERATURE SENSORS 2-128
8.5.2 INCLINATION SENSOR 2-129
8.5.3 FUEL SENDER ASSEMBLY 2-130
8.5.4 ROTARY BRUSH
2-131
9. SAFETY DEVICE
2-133
9.1 CONFIGURATION OF MOMENT LIMITER
2-133
9.2 MOMENT LIMITER - NAMES FOR MONITOR INDICATORS (CRANE MODE)
2-134
9.3 SENSOR ASSEMBLY
2-135
9.3.1 LENGTH METER (STANDARD SPECIFICATION) 2-135
9.3.2 LENGTH METER (BOOM LIGHT SPECIFICATION) 2-136
9.3.3 ANGLE DETECTOR 2-137
9.3.4 PRESSURE SENSOR 2-138
9.4 OVER-HOISTING PREVENTION DEVICE
2-139
9.5 OVER UN-WINDING DETECTION DEVICE
2-140
9.6 TRI-COLOUR REVOLVING WORKING STATUS LAMP
2-141
9.7 OUTRIGGER SAFETY DEVICES
2-142
9.7.1 OUTRIGGER POSITION DETECTION PARTS 2-142
9.7.2 OUTRIGGER GROUNDING DETECTION PARTS 2-143
9.7.3 OUTRIGGER ROTARY POSITION DETECTION PARTS 2-144
9.8 BOOM STOWING POSITION DETECTION PARTS
2-145
9.9 HOOK GROUNDING DETECTION PARTS
2-146