4-27
In SETUP you can:
o
Initialize a position
o
Choose a position mode (2D, 3D, or Automatic)
o
Choose a local clock for time display
o
Set the time (local clock)
o
Choose an automatic or manual Route Mode
o
Select the Lat/Lon display
o
Select a Map Datum
o
Enter a Magnetic Variation
o
Select Distance and Speed Units
o
Select Altitude Units
o
Select the Date Order
Before pressing SETUP, take a minute or two and fill out the
worksheet
on page 4-28. Keep the worksheet as a reference, so you
can refer to it
if the unit loses its memory and must be recustomized.
Press SETUP and then the DOWN ARROW to display the SETUP
features
in sequence. Use the RIGHT ARROW to toggle between the
selections
within each feature.
Entering an Initialization Position
The initial position entered here must be correct within 300 miles
(487.2 km). If you are not sure of your position, call your local mari-
ne
electronics dealer or consult an atlas or chart.
The unit should be reinitialized if it is moved more than 300 miles
(487.2 km) from the last fix or suffers a memory loss.
To Next Page
Loading...
Need help?
General