Mahr Millimar C 1202 - Page 19

19
Mahr GmbH • Millimar C1202
!
The instrument is most accurate after approx. 30 minutes of operation. Inductive
measuring probes should be mechanically set to the electrical zero point before the
rst measurement. To do this, use the Absolute mode that indicates the raw value or
absolute value of the probe.
– Select the relevant measuring probe
type using ▼ or ▲
=> See Technical Data in the operating
instructions for compatible
measuring probes.
– Conrm entry by pressing 4 key or
cancel with Ó key
– Exit submenu with Ó or exit the
settings menu by pressing the
key.