Mahr Millimar C 1202 - Probe Type C1; Probe Type C2

61
Mahr GmbH • Millimar C1202
5.3.3 Probe type C1
– Select the Probe type C1 submenu
using the ▼ or ▲ key.
– Select using 4 key or exit submenu
using the Ó key.
– Select the relevant probe type using
▼ or ▲.
!
If the N 1702 M module is being
used, the measuring signal from the
sensor is multiplied by the following
factor
Standard Range: x 1
Long Range: x10
For compatible probes, see
Section8.2.
– Select using 4 key or cancel using Ó
key.
– Exit submenu with Ó or exit the
settings menu by pressing the
key.
5.3.4 Probe type C2
Select probe type for channel C2
Implement the settings as described
under 5.3.3 Probe type C1.