Mahr Millimar C 1202 - Measuring Time

56
Mahr GmbH • Millimar C1202
5.2.4 Measuring time
The time specications only apply in
"Automatic" mode.
– Select the Measuring time submenu
using the ▼ or ▲ key.
– Select using 4 key or exit submenu
using the Ó key.
– Use the
▼
key to select the digit and
the ▼ or ▲ key to enter the relevant
value.
– Use the 4 key to conrm the value or
Ó to exit the submenu.
If a time other than "0" was set under
"Measuring time", measurement
stops automatically after this time.
A green bar appears in the center
box at the bottom for the duration of
the set measuring time. The length
of the bar indicates the lapsed time.
Measuring time active