Mahr Millimar C 1202 - Display Center at

45
Mahr GmbH • Millimar C1202
3.2.9 Display center at
– Press the ON/OFF key
=> Menu appears.
– Use the Ó key,
▼
or
▼
and to
select the Feature (M1 / M2 / M3)
you wish to congure.
– Select the Display center at submenu
using the ▼ or ▲ key.
– Select using 4 key or exit submenu
using the Ó key.
With asymmetric tolerances, the tolerance eld might displayed outside the scaled
analog display. In this case, it is advisable to center the display to the center of the
tolerance rather than to the nominal size.
– Use the ▲ or ▼ key to select the
relevant centering.
– Use the 4 key to conrm the
selection or Ó to exit the submenu.
– Use the
key to switch to
measuring mode.