Mahr Millimar C 1202 - Configuring Measurement Features; Feature Selection and Formula Setup

22
Mahr GmbH • Millimar C1202
3 Conguring the feature menu
3.1 Select feature
– Press the ON/OFF key
=> Menu appears
– Use the Ó key,
▼
or
▼
and to
select the Feature (M1 / M2 / M3)
you wish to congure.
!
Only the active features will appear
on the measuring screen.
See Section 5.1.1 Setup 1 / Feature
selection
3.2 Conguring the feature
3.2.1 Formula
– Select the Formula submenu using
the ▼ or ▲ key
– Select using 4 key or exit submenu
using Ó key.
=> The formula editor appears
Press the ▼ key to edit the formula.
Factor is selected.