Mahr Millimar C 1202 - Break Time

57
Mahr GmbH • Millimar C1202
5.2.5 Break time
– Select the Break time submenu
using the ▼ or ▲ key.
– Select using 4 key or exit submenu
using the Ó key.
– Use the
▼
key to select the digit and
the ▼ or ▲ key to enter the relevant
value.
– Use the 4 key to conrm the value or
Ó to exit the submenu.
If a time other than "0" is
entered under Break time, a
new measurement will begin
automatically once the Break time
has elapsed.
A green bar appears in the fourth box
at the bottom for the set break time.
The length of the bar indicates the
lapsed time.
The measurement and break
sequence is paused by pressing the
key and resumed with the or
key.
Break time active