2
Mahr GmbH • Millimar C1202
Dear customer,
Thank you for choosing a product by Mahr GmbH. We kindly request that you follow the instructions
below to ensure the long-term precision of your instrument.
We operate a policy of continuous improvement and are constantly developing our products. Therefore,
it is possible that there may be slight differences between the text and illustrations in this document and
the instrument in your possession, especially with regard to type designations. We reserve the right to
make changes to the design and scope of supply, the right to undertake further technical developments,
and all rights relating to translation of this documentation.
© by Mahr GmbH
The following symbols are used in these operating instructions:
General information
!
Caution
Caution, hazard
Failure to follow instructions marked with this symbol can cause inaccurate results and lead to
equipment damage.
Introduction
Permitted uses
The Millimar C 1202 is an electronic length measuring and evaluation instrument for use in production.
Depending on the N 1700 module used, e.g. two inductive or incremental measuring probes, one or two
pneumatic measuring instruments can be connected.
The operating, maintenance and repair information detailed in this quick guide and these operating
instructions must be followed.
To gain maximum benet from this measuring instrument, you must read the instructions before placing
it into operation.
The measuring instrument is most accurate after a warm-up period of at least 30 minutes.
The Millimar C 1202 must only be used with the supplied AC adapter.
The full operating instructions can be downloaded at:
www.mahr.com/products, on the product page.
The scope of delivery of the length measuring instrument includes:
- Millimar C 1202 measuring instrument
- AC adapter with interchangeable adapters
- Bus termination module
- Micro SD memory card
- Quick guide
To Next Page
Loading...
Need help?
General
