Markator FlyMarker mini 85/45 plus - Daily Maintenance; Monitor Marking Quality; Clean the Keyboard; Two-Year Maintenance (General Overhaul)

FlyMarker
®
mini 85/45 plus and 120/45 plus
Operating Manual
141
7.1 Daily maintenance
Visual check on damages of FlyMarker
®
mini, as cracked housing or chipped or damaged parts
of the housing.
Visual check of damages of the marking pin, as plunted marking pin or damaged tip of the
marking pin.
7.1.1 Monitor marking quality
Visually monitor marking quality, compare to a perfect reference marking, for example.
- During shift operation, this inspection should be done
at the end of each shift.
- The duller the marking pin, the less legible the
characters are in small heights.
7.1.2 Clean the keyboard
Risk of damage
The plastic parts of the marking head are not resistant to
acids, lye, ammonia, ethylene chloride, benzoleor methyl
alcohol.
7.2 Two-year maintenance (general overhaul)
The guides normally don’t need to be lubricated. However, at two-year intervals, they should be
inspected.
This general overhaul can only be done at the factory with special equipment.
If FlyMarker
®
mini is indispensable:
MARKATOR
®
will provide a loaner device at a flat rate
for the period of the general overhaul, if an agreement is
made in a timely manner.
Upon request, MARKATOR
®
will be happy to make an
appropriate offer.