When storing, transporting or disposing of the battery,
put the safety cap on its contacts.
If the safety cap is not on, loose metal parts may short
circuit the contacts and cause a fire or explosion.
- Do not cover the charger’s ventilation slot during
charging. Leaving it uncovered prevents the charger and
battery from overheating.
- The battery uses lithium ion technology. The information
on the battery’s model plate must be the same as the
technical data.
- The battery is delivered with a partial charge. Before
using your FlyMarker® mini for the first time, fully charge
the battery.
- Never store the battery in the charger when the charger is
not in operation! When it is out of the charger, the battery
must be stored only with its safety cap.
- Batteries drain while the FlyMarker® mini is not in use, so
charge the batteries regularly. Or better yet: Put the
battery into the plugged-in charger, which will switch to
trickle charging after the main charging is over. This is
especially good for maintaining the battery and keeping it
ready to use.
- For maximum battery life, do not recharge the battery
right after short-term use. If possible, drain it to its lower
charge limit and then recharge it.
- Prevent the machine from blocking, if possible. The
excessive current flow from this causes the battery to
drain and wear out faster.
- When the battery’s operating time gets shorter and
shorter between charges, this shows that the battery is
worn out and needs replacing. Follow the disposal
instructions. Attention!
To Next Page
Loading...
