FlyMarker
®
mini 85/45 plus and 120/45 plus
Operating Manual
Reverse marking
Can be used for multi-line marking to decrease the marking cycle time.
Example:
The first line is marked from left to right, and the second line is marked from right to left.
5.2.2.2 Radial (for marking round parts)
Avoid markings in the air.
When marking round parts, the text arc must be smaller
than the stroke of the marking pin (5 mm).
Marking is done in the middle of prism R of the support plate and transverse to the axis of the
round part.
To Next Page
Loading...
