Chapter 2
Periodic maintenance
Section 2 Maintenance and adjustment
2
—
11
Clean and lubricate
Use the kerosene to clean the chain.
As in Fig. 2.2.27.
If the chain is quickly embroidered, it should shorten
the cleaning interval.
After the chain is cleaned and dried, it needs use
high-viscosity oil to lubricate
Warning：
Re-assemble the chain buckle that the open end is
opposite to the direction of rotation.
In the first 1000Km (5 months) and
thereafter every 4000Km (20 months), it
needs to carry out inspections.
Replace the braking hose every 4 years.
Replace the braking fluid every 2 years.
Braking fluid level
Keep the motorcycle parked upright with the handle
bar straight.
Check the braking fluid level by observing the lowest
limit line of the front braking reservoir.
If the brake fluid level is lower than the limit line ①,
fill up with brake fluid that meets the following
specifications.
As in Fig.2.2.29
Specification and classification:DOT
Front brake disc
By observing the limit line ② on the
brake disc can check the degree of wear
of the brake disc.
When the wear exceeds the limit line,
a new brake disc needs to be replaced.
As shown in Fig. 2.2.30
Fig.2.2.27
Fig.2.2.28
Fig.2.2.29
Fig.2.2.30
Warning:
The brake fluid used in this car is
non-petroleum hydraulic oil.
When refilling fluids, do not use or mix
different types of fluids such as silicon-based,
glycol fluids or petroleum fluids, let alone use
brake fluids from aged, used, or unsealed
containers. Never use the brake fluid left from
the last maintenance or the brake fluid stored
for a long time.
If the brake fluid leaks, it will affect safe
driving and quickly fade the surface painting.
Check the brake hose and hose joints for
cracks and oil leakage.
Note:The whole set of brake disc should be
replaced, otherwise it will affect the braking
performance.
To Next Page
Loading...
