MASSEY FERGUSON 5400 - Removing and Disassembling the

Massey Ferguson 5400 - Issue 1.a
05D02.12
GBA20 Speedshift with Power Shuttle
D . Removing and disassembling the
front cover
Removal (Fig. 6)
7. Take out the screws (24).
8. Using two tabs or two locally made rings, remove
the shaft (36), ring carrier (33) and front cover (27)
assembly.
9. Take out and discard seals (1).
10. Remove and discard the seal rings (31).
Disassembly (Fig. 8)
11. Take off circlip (37). Remove the tab washer (38)
and washer (39).
12. Separate the shaft (36) from the ring carrier (33).
13. If necessary, remove screws (34) (41). Separate
and put aside the ring carrier (33) from the cover.
14. Remove piston (48) (Fig. 7) by lightly tapping the
cover with a wooden wedge or using a jet of
compressed air.
15. Remove seals (22) and (23) and discard them.
N
OTE 1: The annular restrictor (19) is held in the cover
by a Loctite 648 product or similar.
N
OTE 2: Rivets (2) and (11) ensure that the oil pipe is
sealed.
33
27
24
1 31
36
MA-05-00361A
Fig. 6
48
MA-05-00364A
Fig. 7