Massey Ferguson 5400 - Issue 1.a
06H01.6
GPA20 rear wheels / hubs
D . Replacing a wheel stud
6. Drive off the defective stud with the help of a
bronze drift and a hammer.
7. Clean the stud and its housing on the flange.
8. Dry using compressed air.
9. Place several drops of Loctite 270 or equivalent on
the new stud serration.
10. Place the stud in the flange housing, and use a
bronze sledgehammer and suitable hammer to
knock it in until its head meets the inside flange of
the wheel shaft.
To Next Page
Loading...
