MASSEY FERGUSON 5400 - Refitting and Shimming of the Differential Assembly

Massey Ferguson 5400 - Issue 1.a
06E01.18
GPA20 differential
J . Refitting and shimming of the
differential assembly
Refitting the right-hand flange (25)
85. Carefully place the differential assembly in the
housing (Fig. 23).
N
OTE: The right-hand flange (25) is assembled on the
centre housing in a similar way to the left hand flange
(9). The positioning is ensured out by the locating ring
(45).
86. Use the assembly method described in § D.
Refitting the left-hand flange (9)
87. Remove the bearing cup (14) and deflector (13)
from the flange (9).
88. Place the bearing cup on the cone (17).
89. Fit the tool ref. 3376847M91 on the housing, using
two screws (56) tightened to a torque of 85 - 100
Nm (Fig. 24).
90. Tighten the central screw to a torque of 10 Nm.
N
OTE: Check that the ring gear is not constrained
by the drive pinion and turn it several times to
correctly seat the bearing cones in their cups.
Check the tightening torque of the central screw of
the tool once again.
91. Assemble and moderately tighten the hexagonal
calibrated spacers “A” (Fig. 24) in the other two
holes. Check that they are in contact with the
housing.
Fig. 23
Fig. 24