MASSEY FERGUSON 5400 - Disassembling and Reassembling the Rear Bearing

Massey Ferguson 5400 - Issue 1.a
07C01.7
GPA20 removable shaft
Refitting
12. Fit the shaft and the rear bearing assembly (Fig. 6).
13. Smear two screws (16) with Loctite 542, then
tighten to a torque of 105 - 120 Nm.
14. Take out two guide studs.
15. Coat the two other screws (16) with Loctite 542,
then tighten to a torque of 105 - 120 Nm.
16. Top up the rear axle housing with oil.
D . Disassembling and reassembling
the rear bearing
17. Remove the rear bearing and repeat operations 8
to 11.
Disassembly
18. Remove the O'ring (19).
19. Remove snap ring (20).
20. Separate the shaft (10) from the bearing assembly.
21. Remove the O'ring (11).
22. Take off circlip (7).
23. Separate the unit (12) from the roller bearing (15)
(Fig. 7).
24. Remove the snap ring (8).
25. Extract the roller bearing (15) from the hub (9).
26. Remove the sealing ring (14).
Reassembly (Fig. 7)
27. Smear the external diameter of the sealing ring
(14) with Loctite 542.
28. Using a press and a suitable tool, install the sealing
ring (14) in abutment against the shoulder of the
unit (12). The double lip must be turned towards
the roller bearing (15).
29. Assemble the bearing. Reverse operations 17 to
24 and install it. Repeat operations 12 to 16.
Fig. 7