MASSEY FERGUSON 5400 - Adjusting the Control

Massey Ferguson 5400 - Issue 1.a
05J01.8
GBA20 Creeper unit
G . Adjusting the control
27. Place control lever "A" in the "Snail" position (Fig. 4).
R
EMINDER: The control lever can be located in two
positions on the right-hand instrument panel,
depending on whether or not an autohitch is fitted.
28. Screw the clevis (1) flush with the threaded end of
the cable (6) (Fig. 4).
29. Fit the clevis (1) on to lever "A" with clip (7). Tighten
nut (2) (Fig. 4).
30. Screw nut (3) on the sheath end (5).
31. Fit the sheath end and Grower washer on the
support. Tighten nut (4).
I
MPORTANT: Check that the cable is not pinched.
32. Position guide rod link "B" on "creeper unit" position
(Fig. 5) (reducer dog (8) engaged towards the rear
(Fig. 1), fork locked.
33. Screw the clevis (9) flush with the threaded end of
the cable (6) (Fig. 5).
34. Fit clevis (9) on link B using clip (10). Tighten nut
(11) (Fig. 5).
35. Adjust the stop (12) with the nut (13), making sure
that guide rod link "B" is still effectively locked.
36. Tighten nut (14).
I
MPORTANT: After tightening, check that there is no
tension on the cable.
37. Check that the "direct drive" position is locked.
MA-05-06021A
3
4
6
7
2
A
1
5
C
Fig. 4
10
11
13
14
B
12
11
9
9
MA-05-00515B
6
Fig. 5