Massey Ferguson 5400 - Issue 1.a
06B01.11
GPA20 Normal Duty Trumpet housings
F . Replacing a lug stud
88. Drive off the defective stud with the help of a
bronze drift and a hammer.
89. Use a brush and solvent to clean the streak marks
left by the stud on the shaft flange.
90. Dry using compressed air.
91. Place several drops of Loctite 270 on the new stud
serration.
92. Place the new stud over the serration marks left by
the former stud.
93. After checking that splines are properly engaged,
bring the stud head towards the inner flange of the
axle shaft with a bronze hammer.
To Next Page
Loading...
