MASSEY FERGUSON 5400 - Removing and Refitting the Forward Clutch

Massey Ferguson 5400 - Issue 1.a
05C02.13
GBA20 Power Shuttle
B . Removing and refitting the
forward clutch
Preliminary operations
1. Disassemble the tractor between the engine and
the gearbox (see section 2).
2. Drain the gearbox and the centre housing.
3. Remove the spacer (4) from the gearbox (see
section 3).
4. Remove the pipes (86) and (87).
Detach and remove the covers (37) (83), the flange
(80) and the pipe (78) (Fig. 3).
5. Remove the pipes (31) (74) (76) (94) (Fig. 3).
Removal
6. Remove the forward clutch (2) (Fig. 5) and pull it
from the housing using a locally made tool (see §
G).
Refitting
7. Clean the components. Replace any defective
parts.
N
OTE : If forward clutch shimming is necessary,
refer to § D.
8. Check that PTO shaft (1) is installed (Fig. 5).
9. Refit the clutch using the tool used for removal.
1
2
MA-05-02008A
Fig. 5